Vacu Vise

Vacuum vise or chuck

Eliminate Specialized Fixtures!

Holds thin, flat, or irregular shaped parts
Flexible foam gasket fits all parts
Works with flood coolant
Runs off shop air (no vacuum pump needed)
Reduces fixture setup and tear down time
Machine whole parts with one setup
Ideal for aluminum, copper, plastic, ceramics, steel, and graphite

top
vacu-vise logo.gif (2758 bytes)

Product Information - Table / Generator / Fixtures / Technical Specifications

Table
The base and top plate of the Vacu-Vise™ are constructed of high-grade anodized aluminum with stainless steel fastener hardware. Delrin strips are used for part squaring. For part-holding, foam gasket material fits into the grid matrix channels to create a vacuum seal around the part periphery. Side clamps and Mitee Bites clamps provide an additional holding option.

tableandpart.jpg (52360 bytes)

Part Number #V V1212

Keyed for quick set up
Holds aluminum, plastic, ferrous and other non-ferrous materials
Easily configured to hold thin, flat, or irregular shaped parts
Excellent for machining under flood coolant conditions
Replaceable top matrix plates available

Part Number #VG01

Venturi Vacuum Generator

Operates off shop air
No moving parts to deteriorate
Easy mounting
2 liter container for coolant overflow capture
Slide valve for quick clamping and release
Vacuum gauge included

Vacu-Vise™ Fixtures

#V V1212

The 12" x 12" table comes with the following hardware:

2 - 11" low profile plastic guide bars

3 - slide clamps

3 - Mitee-bite™ clamps

2 - Sine-keys to fit a .625" slotted machine table

1 - *" tubing fitting

1 - 50' roll of *" closed celled gasket cord

#V V2416

The 24" x 16" table comes with the following hardware:

4 - 11" low profile plastic guide bars.

6 - slide clamps

6 - Mitee-bite™ clamps

2 - Sine-keys to fit a .625" slotted machine table

1 - *" tubing fitting

1 - 50' roll of *" closed celled gasket cord